Bay BayStack 400-ST1 Bedienerhandbuch PDF herunterladen (Seite 29)

Assigning a New Base Unit to the Stack

To assign a new base unit to the stack, complete the

following steps:

1. Set the Unit Select switch on the original base unit

to the Off position.

See Figure 9

on page 20 for details about the Unit

Select switch.

2. Set the Unit Select switch on the new base unit to

the Base position.

3. Renumber the Stack.

See the Using the BayStack 450 10/100/1000 Series

Switch guide for detailed information on how to

renumber the stack configuration.

Note:

Bay Networks recommends that you

always configure the top unit in the stack as the

base unit.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 39 40

Keine Kommentare

Bay BayStack 400-ST1 Bedienerhandbuch Seite 29